Found 5218 results for: Ccna 5 Exam Answers
Which two statements are true about NTP servers in an enterprise network? Choose two. NTP servers at stratum 1 are directly connected to an authoritative time source. NTP servers ensure an accurate time stamp on logging and debugging information....
Found: 24 May 2021 | Rating: 92/100
Physical topologies are concerned with how a network transfers frames. Which layer of the hierarchical design model is a control boundary between the other layers?
Found: 24 May 2021 | Rating: 92/100
ACLs assist the router in determining the best path to a destination. Standard ACLs can restrict access to specific applications and ports. ACLs provide a basic level of security for network access. ACLs can control which areas a host can access on a network. Explanation: ACLs can be used for the following:Limit network traffic in order to provide adequate network performance Restrict the delivery of routing updates Provide a basic level of security Filter traffic based on the type of traffic being sent Filter traffic based on IP addressing What is the only attribute used by standard access control lists to identify traffic?
Found: 19 Apr 2021 | Rating: 87/100
Choose two. Destination and source MAC addresses have local significance and change every time a frame goes from one LAN to another. Destination IP addresses in a packet header remain constant along the entire path to a target host. Destination MAC addresses will never change in a frame that goes across seven routers. A packet that has crossed four routers has changed the destination IP address four times. Every time a frame is encapsulated with a new destination MAC address, a new destination IP address is needed. What are two features of ARP? If a host is ready to send a packet to a local destination device and it has the IP address but not the MAC address of the destination, it generates an ARP broadcast. If no device responds to the ARP request, then the originating node will broadcast the data packet to all devices on the network segment. Refer to the exhibit. In this scenario, what will happen next? A host is trying to send a packet to a device on a remote LAN segment, but there are currently no mappings in its ARP cache.
Found: 4 Apr 2021 | Rating: 88/100
ITExamAnswers: Free Computer Networking Study Guide & Labs
How will the device obtain a destination MAC address? It will send the frame and use its own MAC address as the destination. It will send the frame with a broadcast MAC address. What are two potential network problems that can result from ARP operation? On large networks with low bandwidth, multiple ARP broadcasts could cause data communication delays. Large numbers of ARP request broadcasts could cause the host MAC address table to overflow and prevent the host from communicating on the network.
Found: 17 Apr 2021 | Rating: 92/100
A network administrator is connecting two modern switches using a straight-through cable. The switches are new and have never been configured. Which three statements are correct about the final result of the connection? Choose three. The link between the switches will work at the fastest speed that is supported by both switches. The link between switches will work as full-duplex. The auto-MDIX feature will configure the interfaces eliminating the need for a crossover cable. The connection will not be possible unless the administrator changes the cable to a crossover cable. The duplex capability has to be manually configured because it cannot be negotiated. If both switches support different speeds, they will each work at their own fastest speed. Which method of memory buffering would work best for this task? When would a switch record multiple entries for a single switch port in its MAC address table?
Found: 5 Apr 2021 | Rating: 90/100
The exhibit shows a small switched network and the contents of the MAC address table of the switch. PC1 has sent a frame addressed to PC3. What will the switch do with the frame? The switch will forward the frame to all ports except port 4. The switch will forward the frame to all ports. The switch will forward the frame only to port 2. The switch will discard the frame. The switch will forward the frame only to ports 1 and 3. Which two statements describe a fixed configuration Ethernet switch? A fixed configuration switch may be stackable. The number of ports on the switch cannot be increased. An SVI cannot be configured on the switch. The port density of the switch is determined by the Cisco IOS. The switch cannot be configured with multiple VLANs.
Found: 17 Apr 2021 | Rating: 90/100
Explanation: Down state: No hello packets are received. Init state: Hello packets received, but bidirectional communication not established. Exchange state: Exchange of DBD packets occurs. Loading state: Request for additional information is sent. Full state: Routers converged and neighbors are fully adjacent. A network engineer is troubleshooting an OSPFv2 network and discovers that two routers connected by a point-to-point WAN serial link are not establishing an adjacency.
Found: 13 Apr 2021 | Rating: 91/100
Which two requirements to form an adjacency need to be verified? Choose two. Verify that one of the interfaces that connects the two routers is active and the other passive. Verify that the interfaces that connect the two routers are in the same subnet. Which command is used to verify that OSPF is enabled and also provides a list of the networks that are being advertised by the network? The command show ip interface brief is used to check that the interfaces are operational. The command show ip route ospf displays the entries that are learned via OSPF in the routing table. The command show ip protocol s checks that OSPF is enabled and lists the networks that are advertised.
Found: 26 Apr 2021 | Rating: 87/100
CCNA 1 (v5.1 + V6.0) Chapter 5 Exam Answers For Ethernet
Refer to the exhibit. However, none of the routers are receiving routing updates. What is the cause of the problem? The routers are using IPv4 addresses for router IDs. All of the routers have an OSPFv3 interface priority of 0. The routers are using IPv6 link local addresses to communicate. These two routers are configured to run OSPFv3 but they are not forming a neighbor adjacency. The routers have the same priority. The routers have both been elected as the DR. The routers are configured with the same router ID. No router ID has been configured. This is because no router ID has been configured on this router. If the router ID is not manually specified then an IPv4 address from one of the interfaces is used instead. This router has no IPv4 addresses configured on it so a router ID cannot be automatically chosen.
Found: 26 Apr 2021 | Rating: 87/100
CCNA 2 V6.0 Chapter 5 Exam Test
All routes for the entire network will be present. Directly connected networks that are operational will be in the routing table. A summary route for all previously learned routes will automatically appear in the routing table until all LSPs have been received by the router. During verification or troubleshooting of the OPSFv3 configuration on a router, which three parameters are displayed by the show ipv6 ospf interface command?
Found: 26 Apr 2021 | Rating: 91/100
CCNA Security V Chapter 5 Answers - Implementing Network Security
Choose three. The PT initialization was skipped. You will not be able to view the PT activity. Open the PT Activity. Perform the tasks in the activity instructions and then answer the question. Issue the clear ip ospf process command. Add the network Match each OSPF state to its function. Not all options are used. A network engineer is researching dynamic routing protocols and how much time it takes for a network to converge. What does it mean for a router to achieve convergence?
Found: 12 Apr 2021 | Rating: 89/100
CCNA 1 V5 Introduction To Networks Exam Answers
The entrance card will contain all the necessary details for the examination. Answer to research question RQ5: What main results and conclusions have been drawn based on big data and IoT in environment applications? To answer this question, our 45 selected articles are evaluated according to the application domain, data source, data type, data processing type, architecture details, and main findings, as shown in Table 8. The format of the test may include multiple choice, short answer 5 sentences or less , and short essay paragraphs. A new network administrator has been asked to enter a banner message on a Cisco device. Which character is used within a search engine to gather data.
Found: 25 Apr 2021 | Rating: 92/100
CCNA 1 Chapter 5 V Answers | Fahem Inding
A virus can be used to deliver advertisements without user consent, whereas a worm cannot. You must use these answers to prepare yourself for the exam or to test your knowledge. Q1 Change will have to occur in the corporate network in order to prepare for the Internet of Things. WAN is another name for the Internet. Introduction to Cybersecurity ITC v2. Which character is used within a search engine to gather data efficiently by placing the character before and after the name of a particular person? What is a characteristic of a fault tolerant network?
Found: 22 Apr 2021 | Rating: 87/100
CCNA 4 V Chapter 5 Exam Answers PDF | 1medicoguia.com
Please attach the answer script template in the beginning of your script. This exam offer may be redeemed to take one 1 Microsoft Certification exam, delivered at an authorized Pearson Vue testing center or through a Pearson Vue online proctoring site. It is an ongoing effort to protect Internet-connected systems and the data. In , the IoT is better prepared to thrive. Which two types of institutions do malicious web pages.
Found: 16 Apr 2021 | Rating: 91/100
Practice Final v6. IT Essentials 7. What is a disadvantage of deploying a peer-to-peer network model? Which two ports can be used for the initial configuration of a Cisco router? Certificate will have your name, photograph and the score in the final exam with the breakup. Q2 What does IOT stand for? What is IoT? Which character is used within a search engine to gather data efficiently Which security best practice involves defining company rules, job duties, and expectations? The projects published from this server should be linked from the project's official landing page, usually in Drupal on www.
Found: 5 Apr 2021 | Rating: 86/100
No comments:
Post a Comment